PROCEDUREv2.10
LOAD TEST IMPLSLOG/R
LOAD WAVEFORM THREEWAY/R
1/R
EDIT COMMENT /E
UTIL PROMPT /R
/R
/R
/R
      The following screen will display the first 50 milliseconds of/R
      the stored impulse response.  Use the graphics cursor to/R
      determine the time where the impulse starts to build up, and/R
      the time just before the first reflection arrives./R
/R
      Press <Enter> to view the impulse, and press <Enter> again when/R
      when you have determined these times./E
/F6/F10/E
UTIL PROMPT /R
/R
/R
/R
      On the SWEEP DEFINITIONS panel, enter the time you have just/R
      determined as the start of impulse build-up into the SOURCE-1/R
      START field and press <Enter>.  Enter the time just before/R
      the first reflection into the SOURCE-1 STOP field and press/R
      <Enter>.  Remember to use the "m" abbreviation for milliseconds./R
      These times for the first-arrival signal will be sent to the DSP/R
      unit and the expanded first-arrival signal will be plotted./R
/R
      Press <Enter> to move to the SWEEP DEFINITIONS panel.  Press/R
      <Enter> again after viewing the expanded first-arrival signal./E
PANEL ss/F10/R
/F10/R
/F6/F10/E
UTIL PROMPT /R
/R
/R
/R
/R
      The following screen displays the anechoic frequency and phase/R
      response of the loudspeaker./R
/R
      Press <Enter> to view, and press <Enter> again after viewing./E
LOAD TEST resphase/R
/F6/F10/E
UTIL END