PROCEDUREv2.10
LOAD TEST AMP/R
UTIL PROMPT /R
/R
/R
/R
      On the GENERATOR control panel displayed on the following/R
      screen, use the space bar and <Enter> key to select/R
      balanced or unbalanced generator output to drive the/R
      amplifier/R
     /R
      Press <Enter> when the selection is made.  Press <Enter>/R
      now to obtain the GENERATOR panel./E
PANEL ga/F10/R
/E
UTIL PROMPT /R
/R
/R
/R
      On the ANALYZER control panel on the following screen, use/R
      the numeric keys on the keyboard to enter the resistance/R
      value of the power dummy load resistor which the amplifier/R
      is connected to for the tests.  Press <Enter> after typing/R
      in the correct resistance value./R
/R
      Press <Enter> to obtain the ANALYZER panel./E
PANEL /E
PANEL lr/F10/R
/R
/E
UTIL PROMPT /R
/R
/R
/R
      On the SWEEP DEFINITIONS panel on the following screen, use the/R
      numeric keys to enter the desired sweep start and stop frequencies/R
      for the frequency response and distortion vs frequency tests.  Press/R
      <Enter> to obtain the SWEEP DEFINITIONS panel.  Press <Enter> to make/R
      each selection./E
PANEL ss/F10/R
/F10/R/E
UTIL PROMPT /R
/R
/R
/R
/R
      On the REGULATION panel on the following screen, use the numeric/R
      keys to enter the power output value from the amplifier to which/R
      the response and noise tests will be referred and at which the/R
      distortion tests will be run.  Press <Enter> to obtain the/R
      REGULATION panel, and press <Enter> after typing in the correct/R
      power value./E
PANEL rm/F10/R/E
SAVE TEST /R
UTIL PROMPT/R
/R
/R
      Connect generator A and B outputs to power amplifier left and right/R
      inputs.  Connect power amplifier outputs to suitable dummy load/R
      resistors and to the A and B inputs of the analyzer./E
LOAD OVERLAY AMP-RESP/R
/C3/F4/F9/E
PANEL ‡/E;restore punched-out fields
SAVE TEST AMPRESP/R
LOAD OVERLAY AMPNOISE/R
/F9/E
PANEL ‡/E; restore punched-out fields
SAVE TEST AMPNOISE/R
LOAD OVERLAY AMP-THD/R
/F9/E
PANEL ‡/E;restore punched-out fields
SAVE TEST AMP-THD/R
/F1/E
UTIL PROMPT/R
/R
/R
            CAUTION:  DISCONNECT POWER AMPLIFIER OR TURN DOWN/R
                      GAIN TO AVOID DAMAGE WHEN OTHER DEMONSTRATION/R
                      PROCEDURES ARE RUN./E
RUN EXIT
UTIL END